2016+ Axis Plug-and-Play Rear Bag Installation

Product Part #: 42407

Product Name: Axis Plug-and-Play Rear Ballast Upgrade

Installation Difficulty: 1 of 5

Installation Time: Five minutes

Required Tools: None

Optional Tools: None

Instructions:

Step 1: Empty rear lockers on either side of engine compartment
Step 2: Remove Ballast bag from box and layout on floor of boat.
Step 3: Locate alignment graphic (insert image here that shows graphic on bag) and position bag correctly in the rear locker.
Step 4: Slide the red locking ring back on the rear connector hose to remove the plug.
Step 5: Connect the fitting at the rear of the locker first by inserting the fitting on the bag fully, and then sliding the red locking ring down towards the bag.
Step 6: Move the front of the bag and repeat the process for the forward connection.
Step 7: Optional, if you have the AutoVent feature, remove the pre-installed plug fitting from the vent/overflow port on the top of the ballast bag. Thread the included 3/4" Male Quick Connect fitting into place. Attach the smaller AutoVent hose using the same process as the other connections.

Note: If your boat is not equipped with AutoVent, we offer an AutoVent Upgrade Kit to add that functionality that is recommended for the system to function correctly.